Everything we do to stone.
Twelve services, one method: diagnose what the surface actually needs, then restore it in place. Each page says what the problem is, what we do about it, and what it does not fix.
Marble floor polishing
Diamond-cut back through the grits and brought up to a true reflective finish, not a topical shine that wears off in a season.
Marble benchtop restoration
Etching from citrus, wine and bench spray is dissolved stone, not a stain on top. It is cut back and re-polished in place, usually in a day, with no removal.
Marble bathroom restoration
Vanities, shower floors and walls get the wrong cleaners for years. We strip the haze, correct the etching and reseal so the room reads as new again.
Etch and stain removal
Stains sit in the stone and are drawn out with a poultice. Etches are stone that has been dissolved and are cut back. Getting the diagnosis right is most of the job.
Anti-etch protection film
A clear protective film bonded to a freshly restored benchtop. It takes the acid, the heat and the knife so the marble underneath does not. The one product that genuinely stops etching.
Stone cleaning and sealing
Deep clean with the right chemistry for the stone, then an impregnating sealer that goes into the pores rather than sitting on top. Sealing slows staining; it does not stop etching, and we say so.
Chip and scratch repair
Chips are colour-matched and filled so the repair disappears at arm's length. Scratches are ground out and the area re-polished to match the surrounding finish.
Tile and grout restoration
Grout is the first thing to fail and the first thing people see. Deep-cleaned, recoloured where it has gone past cleaning, and sealed so it stays that way.
Outdoor stone restoration
Sandstone, travertine and limestone outside take salt, algae and weather. Pressure-cleaning alone strips the surface; we clean, treat the growth, and seal for the exposure.
Commercial stone maintenance
Lobbies, foyers and stairs with real foot traffic. Restored after hours, then kept on a maintenance schedule so the building never has to go through a full restoration again.
Engineered stone repair and polishing
Engineered stone can be polished and repaired, within limits. Heat marks, chips and dull patches are fixable; deep resin burns are not, and we tell you which is which before starting.
Granite cleaning and restoration
Granite is hard but not stain-proof. Oil and water marks are drawn out, the surface is re-polished and sealed with a product rated for the density of the stone.
What we will not do.
Six things that get sold as stone restoration. The reasons are chemistry, not preference.
Crystallise a marble floor
A spray-and-buff acid reaction that gives a fast shine and changes the surface chemistry. It makes the next proper restoration harder. We cut back and polish instead.
Coat stone to make it shine
Topical coatings scratch, yellow and wear in the walkways, then have to be stripped. The shine you get from us is the stone's own surface.
Promise a sealer that stops etching
No sealer does. Only a film does. We will not sell you one that claims to.
Pressure-wash sandstone or travertine
It strips the binder and opens the stone. We treat the growth and clean at a pressure the stone can take.
Seal over dirt
Sealing locks in whatever is under it. The stone is cleaned and dried first, every time.
Process engineered stone without notification and controls
Since 1 July 2024 that work must be notified to the WHS regulator and done wet or extracted, with respiratory protection. We will not quote it any other way.